Surviving a critical situation can be difficult without extreme strategies. For example, you may find that your car tires are flat and can’t go to the gas station for repairs.
A bike pump is available in your garage, but you’re not sure if you can use it to repair your bike pump. The quick answer is that it works, but you need to follow a few procedures to get it right.
When inflating a tire, the first thing to do is to make sure it’s on a flat surface. It will help you tell if the tires are getting enough air to move. This allows you to read tire pressure more accurately. You can also easily balance the pump by ensuring the tires are level.
Know about the PSI
You don’t need to know every day, so you need to think about it. However, you must know the PSI (pounds per square inch) pressure required to inflate your tires properly; you can find information in several places. This information is usually on the tire itself, on the rubber. If the tire isn’t worn, it’s a similar size to the tire (if it is, it’s probably time to change it).
You can find it inside the door, usually on a sticker, or you can look it up online in your car’s owner’s manual (if a physical copy is no longer available). Make sure you read everything carefully. When you get information from the tires, check the front and rear tires, as some vehicles have different tire and pressure requirements for the rear tires.
Related post: Is It Dangerous To Fill Tires With Engine On
Determine how low your tire pressure
As a responsible driver, you should keep a pressure gauge in your vehicle’s glove box and always be prepared for an emergency. It’s part of the “standard” maintenance kit that you should carry with you. Start by cleaning any dirt or grime from the valve, then follow these simple procedures to determine how low your tire pressure is:
- Match the opening of the tire gauge with the top of the valve stem (valve). Push it firmly into the valve until the hissing of escaping air stops. Then let go.
- With most pressure gauges, the pressure is indicated by a slide that shoots from below. To determine the actual pressure, look at the marking closest to the end of the pressure gauge.
- Determine how much your tire pressure is below the acceptable PSI. When it reached 5 PSI at the proper pressure, it would help if you inflated the tire.
As a side note, when adjusting the air pressure on one of the tires, check the other tires, as low pressure isn’t always noticeable.
Read more at: Top 8 Best Ford Fusion Tires
How to use a bicycle pump for tire car
The basic concept of using a pump is simple, but there are a few things to check before inflating a tire. An essential part of any bike tool kit, bike pumps can be fitted with various valves, including American valves (also known as American valves) and Presta valves. The end of a bicycle pump with a Presta valve is a thin, threaded metal barrel. These do not apply to car tires. You will need a US valve, which is included in many pumps with a Presta valve and has threads for the nut with a small metal stud inside.
Connect the air valve on your tire to the bicycle pump valve. It’s usual to hear air escaping until the seal is formed. Raise and lower the pump bar steadily with the valve in place. You should check your tire pressure often to avoid overfilling the tire. Reattach your bicycle pump and start over if you haven’t reached the appropriate pressure level yet.
Remember that bicycle pumps are far slower than motorized pumps at filling tires, so that it may take some time. It would even help if you aimed to drive your car without exceeding 5 PSI of the recommended pressure. Replace the valve caps. While it isn’t ideal, you can use a bicycle pump to improvise when you need to pump up your automobile tires. The most important things are to remember which sort of valve you need on your pump. Measure the pressure, so you don’t overfill or underinflate the tire, and start the procedure on a smooth, flat surface with nothing in the way. With a bit of effort to pump the air, you can quickly fill a car tire with a bicycle pump if you follow these guidelines. When you’re finished, screw them on tightly, so they don’t come off.
